Monday, 21 January 2013

Full guide on how to unroot and back to stock for galaxy ace plus S7500


 



!!!DONT TRY IT ON OTHER VARIANTS!!!

Do it on your own responsibility! if you follow this guide properly u will be on the safe side





Before we proceed, make sure:

1-You have installed your Samsung Galaxy Ace Plus S7500 USB drivers on your PC (the easiest way is to install kies).
2-You need to enable USB debugging mode which is deactivated by default.
3-Your Ace Plus S7500 should have 70-80% charge remaining.
4-Your Ace Plus S7500 should be factory unlocked.
5-Backup your important data like Call logs, SMS and other data stored in phone memory in case if anything goes wrong, your data is not hurt.
6-Make sure that kies program is not running & disable antivirus.
This guide is only for Galaxy Ace Plus S7500. So don’t bother to try it on other devices.




How to do it:

Step 1) Turn OFF your mobile and go to Download Mode by pressing and holding the Volume Down + Home Buttons together for few seconds followed by Power button until you see Android logo, then volume up.

Step 2) Now open ODIN on your PC and connect your Galaxy Ace Plus S7500 to your computer.

Step 3) Once your phone is successfully connected to your PC, the ID:COM box on ODIN will turn yellow and will show the COM port number.

Step 4) unzip the downlowded file. u will get a Home.tar file.

Step 5) click on pda (in odin) and choose the file "Home.tar"

Step 6) check "Auto Reboot" and "F. Reset Time" options and make sure that "Re-Partition" is unchecked

Step 7) Click on Start button in ODIN window to start the installation process. The process will take few minutes to complete.

DO NOT UNPLUG USB CABLE WHILE EXECUTING THE PROCESS, YOU MAY BRICK YOUR PHONE!

Step 8) When the installation is completed, you read a green "PASS". your phone will restart.


It is recommended to make hard reset after flashing to have a fresh official firmware

Download Links:

PDA: S7500JPLG1
CSC: S7500OJPLG1
Version: 2.3.6
 
                                                               -XDA

No comments:

Post a Comment